Firmware WB.15.18.0007 resolves the issue, see below
A colleague of mine found an issue with the latest HP 2920 switch firmware.
If you create VLANs using the CLI Menu, the switch reboots and the configuration is not saved.
We have reported this to HP, but is currently being treated as a non critical issue as when creating a VLAN via the web interface or native CLI, the issue doesn’t happen.
We have also noticed on this firmware the switch seems to be less responsive. Luckily we had a few units in stock that we could replicate this issue on, and can confirm downgrading to the previous firmware version removes the issue.
A quick cheers to my colleague Marco for finding and researching this issue.
Switch: HP 2920-48G-POE+
Primary Image : 12852982 08/12/15 WB.15.18.0006
Software revision : WB.15.18.0006
Go to the Main Menu
Select (2) Switch Configuration…
Select (8) VLAN Menu…
Select (3) VLAN Port Assignment
Modify the tagging mode for a port
Switch reboots and doesn’t save configuration
Hopefully HP will release a fix for this firmware soon, as mentioned we have recreated this issue in production and test.
Note: that if you use the vcsu.exe tool and have mutliple flex-10 modules connected together in a domain, the firmware will update all the modules at once, you cannot upgrade just 2 modules of 4, for example.
How to update the Virtual Connect Manager
Note: Please plan downtime for this, as in my case it took everything offline whilst updating both modules.
So to update the Virtual Connect Manager, leave the web interface, as you don’t do it there, you need to download the “Virtual Connect Support Utility”, you can find the latest version here.
To do this, you open up the command interface,
As you can see this launches a command prompt in the install area of the utility.
1. Type vcsu.exe and enter
2. Type update and enter
3. Enter the IP address of the Onboard Administrator, username and password.
4. Drag your firmware file from its location into the CMD prompt window and this will automatically out the file location in for you.
4. Click through the options until it says “Initializing, please wait… [Step 1 of 2]”
5. When prompted it will tell you its discovered the Virtual Connect domain, enter the username and password for the Virtual Connect Manager
6. Enter yes after confirming the version you are on and version you are going to.
7. Once done it will tell you its completed and where the log files are loaded.
Here is a full screenshot of the process, with the steps highlighted in yellow with green marks for easy identification.
Things to know about the Virtual Connect Support Utility
it saves everything in your temp location, so where it tells you it’s saved the log, copy the location and open it up
So it doesn’t just output a file which is the copy of your update session, which in this case is called “vcsu-15044.log”
It saves a copy of your Virtual Connect Manager settings before the upgrade, of which mine was called “vcConfig-8895406-BLE01_vc_domain-201408130822”
And finally there is the Support Info output which can be used by HP support to determine the status of your hardware before and after the firmware update “vcSupportInfo-8895406-BLE01_vc_domain-201408130823”
If you run the “collect” command, then it produces an output to the temp location for the following files
My previous posts in the series covered getting the Cisco UCS up and running and into production, and it seems that adding how to upgrade the Firmware on the UCS at the end of the series is best, as you will find yourself needing to do this once the system is in production as well.
Note: Many thanks to Rene again for this simple post helping me through the steps.
Note2: It’s also worth looking through this short article on the do’s and don’t of UCS Firmware updates, from a session held at Cisco Live 2014.